I just finished up painting his front bezel this weekend with the borderlands theme and now it's on to working on the Mod to the side panel for the window. (This might take awhile). Looking at the panel again I need to research on u channel. The t3500 panel is thicker than my other PC I put a window on and has ridges everywhere.
- 2Working On Your Computer
- 2Before Working Inside Your Computer
- 2Recommended Tools
- 3Turning Off Your Computer
- 3After Working Inside Your Computer
- 4Adding and Replacing Parts
- 5Specifications
- 10Dell Diagnostics
- 10When to Use the Dell Diagnostics
- 10Starting the Dell Diagnostics From Your Hard Drive
- 10Starting the Dell Diagnostics From the Drivers and Utilities Disc
- 11Dell Diagnostics Main Menu
- 12Diagnostic Light Codes
- 13Beep Codes
- 18System Setup
- 18Boot Menu
- 18Entering System Setup
- 20Removing the Cover
- 23Front Bezel
- 23Removing the Front Bezel
- 26Hard Drives
- 26Removing the Hard Drives
- 36Removing the Battery
- 40Video Card
- 46Heat Sink and Processor
- 46Removing the Heat Sink and Processor
- 60Power Supply
- 60Removing the Power Supply
- 70Optical Drive
- 70Removing the Optical Drive
- 74Supported Memory Configurations
- 74Removing and Replacing Memory Modules
- 80Expansion Card
- 80Removing the Expansion Card
- 85Front Fan Assembly
- 85Removing the Front Fan Assembly
- 90System Board
- 90Removing the System Board
Knowing how to remover the inside door panels of your Ford van is a handy skill to have. With this knowledge in hand, you'll be able to avoid an expensive trip to the shop if you need to get inside the door for repairs like replacing a window motor, putting window back on track, or replacing speakers.
Step 1
Pry the sail panel off (the triangular plastic piece at the leading edge of the window) by inserting your panel tool at the top edge.
Step 2
Remove the Phillips screw that is exposed. Set the panel and the screw aside.
Step 3
Pry off the trim that is behind the door pull. Start at the front edge and work towards the bottom edge to release it.
Step 4
Remove the Phillips screw that is exposed. Set the trim piece and the screw aside.
Step 5
Pry off the screw cover at the bottom back edge of the door. Remove the Phillips screw that is exposed. Set the screw cover and screw aside.
Step 6
Pry up the panel on the armrest that contains the power window controls. Remove the Phillips screw that is exposed and set it aside.
Lift the door panel straight up and away from the door body to remove the panel.
Items you will need
- Phillips screwdriver
- Flat screwdriver
- Panel tool